Next  |  Prev  |  Up  |  Top  |  Index  |  JOS Index  |  JOS Pubs  |  JOS Home  |  Search


Modeling the Lips and Mouthpiece

Figure 9.58: Schematic of a brass player's lips at a mouthpiece.
\includegraphics{eps/brasslips}

Figure 9.58 depicts a schematic of a brass-player's lips positioned within a mouthpiece. The air pressure10.22 is denoted $ p_m$ inside the mouth, $ p_l$ between the lips, and $ p$ within the mouthpiece cup.

A simple first approximation is to assume that the air flow through the lips is inviscid (``frictionless'') and incompressible. In this case, the pressure between the lips is governed by Bernoulli's equation (see §B.7.4):

$\displaystyle p_m = p_l + \frac{1}{2}\rho u_l^2
$

where $ \rho$ is the air density (mass per unit volume) and $ u_l$ denotes the particle velocity (see §B.7.1) (distance per unit time) between the lips. The particle velocity $ u_m$ in the mouth is so small that it is usually neglected (approximated by zero).

Following Cullen et al. [98] and previous researchers [160,162], one may assume that the flow between the lips creates a jet in the mouthpiece having velocity $ u_l$ . The pressure within the jet is therefore $ p_l$ , the same as between the lips. The jet is assumed to mix turbulently with the air in the mouthpiece so that it dissipates its energy without raising pressure in the mouthpiece.10.23

One- and two-mass models were also developed by Rodet and Vergez [391,537]. An early one-mass, ``swinging door'' model that works surprisingly well is in Cook's HosePlayer [89] and and TBone [88]. It is also used in the Brass.cpp patch in the Synthesis Tool Kit [91]; in this simplified model, the lip-valve is modeled as a second-order resonator whose output is squared and hard-clipped to a maximum magnitude.

The acoustic tube in a horn can be modeled as a simple digital waveguide [22,37,440,510,532], whether it is cylindrical or conical. More complicated, flaring horn sections may be modeled as two-port digital filters which provide the appropriate reflection and transmission from the bell [39,50,71,118,409,532]. Section 9.7.2 below summarizes a particularly economical approach to brass bell modeling.

It is known that nonlinear shock waves occur in the bore for large amplitude vibrations [199,344]. A simple nonlinear waveguide simulation of this effect can be implemented by shortening the delay elements slightly when the instantaneous amplitude is large. (The first-order effect of air nonlinearity in large-amplitude wave propagation is an increase in sound speed at very high pressures [52].)

It is also known that the bores of ``bent horns,'' such as the trumpet, do not behave as ideal waveguides [429]. This is because sharp bends in the metal tube cause some scattering, and mode conversion at high frequencies. Such points along the horn can be modeled using high-frequency loss and reflection.


Next  |  Prev  |  Up  |  Top  |  Index  |  JOS Index  |  JOS Pubs  |  JOS Home  |  Search

[How to cite this work]  [Order a printed hardcopy]  [Comment on this page via email]

``Physical Audio Signal Processing'', by Julius O. Smith III, W3K Publishing, 2010, ISBN 978-0-9745607-2-4
Copyright © 2023-08-20 by Julius O. Smith III
Center for Computer Research in Music and Acoustics (CCRMA),   Stanford University
CCRMA