John Granzow 250B

From CCRMA Wiki
Revision as of 20:02, 27 February 2013 by Granzow (Talk | contribs)

Jump to: navigation, search

Room/impulse race

This was an initial idea to use an air valve as a mixer, setting in motion a race function between the roundness of the room and the inflation rate (pop time) of the balloon. A microphone would record the burst inside the elastomeric room and deliver a reverb, that might be scaled down to predecit responses of much larger rooms under similar distortions.


IMG 1654.JPG


Fourked tongue

This idea is to advance the evolving daxophone. This mutant splits its voice over four channels into separate horn drivers, filtered by silicone vocal tract models. The models are modular so participants can modify the quadripthong.

IMG 1677.JPG


Splitwire copper Lentils

These copper saucers segment the piano wires from which they suspend. The wire is attached to bridges coupled to the inside of the top and bottom surface. These bridges transfer vibrations from the bowed wire to the lenticular chamber. Adding tension pulls them slightly apart, changing the chamber shape. I would like to try hammering these copper dishes. The hammering could be recorded and played back into the strings via reversed magnetic pickups.

Splitwire.jpg

Beginning to sink Cu with hammer and sand bag.

DSC03047.JPG

A cymbal - to form the sound of its own forming perhaps?

Cymbal.JPG

Xenakis through hi hat: http://www.youtube.com/watch?v=kfigRJ8UuO4

Cymbal2bessel.JPG

600px